| 1. Disconnect a wire from the plug - the storage battery. |
| 2. Remove a steering wheel, the top and bottom casings of a steering column, returnable and contact rings (subsection 8.1, subsection 8.2, subsection 8.3.1 see). |
| 3. Remove a combination of devices (subsection 10.4 see). |
| 4. Remove подрулевой the switch (subsection 10.11 see). |
| 5. Accurately having hooked a screw-driver in places of fastening of latches, remove lateral facings 1 (fig. Removal of lateral facing of the panel of devices see) from both parties of the panel of 2 devices. |
| 6. Remove the panel of the central switch (subsection 10.11 see). |
| 7. Take out the block of safety locks from the panel of devices (subsection 10.1 see). |
| 8. Remove diagnostic колодку, located in a ware box from outside the driver. |
| 9. Turn away screws 2 (fig. Removal of the bottom facing of the panel of devices) fastenings see and remove the bottom facing of 1 panel of devices from outside the driver. |
| 10. Turn away screws 2 (fig. Removal of a ware box) fastenings see and remove from the panel of devices a ware box 3 from outside the passenger. |
| 11. Take out from the panel of devices radio equipment. |
| 12. Remove from the panel of devices switches (fig. subsection 10.11 see). |
| 13. Accurately having hooked a screw-driver, remove facings 2 (fig. the Central console of the panel of devices see) central console of the panel of devices. |
| 14. Remove a ware box of 1 central console. |
| 15. Accurately having hooked a screw-driver on each side, remove an internal part 3 central consoles. |
| 16. Accurately having hooked a screw-driver, remove facing 3 (fig. Removal of facing of management by a heater see) control panels a heater. |
| 17. Turn away two screws of 4 fastenings of the panel of 2 managements of a heater. |
| 18. Turn away nine screws 2 (fig. Removal of a casing of the central console) fastenings see and remove a casing of 1 central console of the panel of devices, having pushed inside the control panel a heater. |
| 19. Turn away four screws 2 (fig. Removal of the amplifier of the panel of devices) fastenings see and remove the amplifier of 1 panel of devices. |
| 20. Remove the central nozzles from the panel of devices (subsection 11.8.1 see). |
| 21. Turn away eight screws 3 (fig. Removal of the panel of devices) fastenings see and remove the panel of 2 devices from an arm 1. |
| 22. Establish the panel of devices upside-down. |
