Skoda Fabia

Since 2000 of release

Repair and car operation



Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
- 8. A steering
   8.1. Removal and steering wheel installation
   8.2. Removal and installation of returnable and contact rings in gathering
   - 8.3. A steering column
      8.3.1. Removal and installation
      8.3.2. Replacement of the case of the switch (lock) of ignition
      8.3.3. Replacement демпфера a steering column
      8.3.4. Removal and installation of an arm of a steering column
   + 8.4. The steering mechanism (without the amplifier)
   + 8.5. The steering mechanism (with the amplifier)
+ 9. Brake system
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes


75d7f213

8.3. A steering column

8.3.1. Removal and installation
THE GENERAL DATA

Connecting Pads the switch (lock) of ignition

1 – connecting колодка
The ignition switch;

2 – a steering column;

3 – "a mass" wire;

4 – connecting колодка an immobilizer;

5 – the case of the lock of ignition

Casing fastening карданного a shaft of a steering column

1 – plastic nuts;

2 – a casing карданного a shaft of a steering column

Fastening of a shaft of a steering column to a shaft приводной gear wheels of the steering mechanism

1 – a shaft приводной gear wheels of the steering mechanism;

2 – a plug карданного the hinge;

3 – карданный a shaft of a steering column;

4 – a coupling bolt

Fastening of a plait of wires on a steering column on the left side

1 – the plait of wires going to
To the switch (lock) of ignition;

2 – the holder;

3 – the additional holder;

4 – a steering column

Fastening of a plait of wires on a steering column on the right side

1 – a plait of wires;

2 – a steering column;

3 – the additional holder;

4 – a cover of the holder;

5 – the holder

Marks of a relative positioning of the top and bottom parts of a shaft of a steering column

1 – a label on the bottom part of a shaft
Steering column;

2 – a label on the top part of a shaft
Steering column

Steering column in gathering

1 – the bottom part of a steering column;

2 – the top part of a steering column;

3 – a transport clamp

Back fastening of a steering column

1 – a shaft of a steering column (a back part);

2 – an arm of fastening of a steering column;

3 – демпфер;

4 – a bolt

Fastening of a steering column

1 – a shaft приводной gear wheels of the steering mechanism;
2 – the holder of plugs;
3 – a bolt of fastening of the holder of plugs;
4 – an arm of a steering column;
6 – a water taking away casing;
7 – демпфер;
5, 8, 9, 10, 12 – bolts;
11 – a steering column;
13 – a coupling bolt

Fastening of the holder of plugs

1 holder of plugs;

2 – a bolt;

3 – a plug on a steering column

The prevention

The steering column is not subject to repair, in case of malfunction it is necessary to replace it in gathering.


Removal

PERFORMANCE ORDER
1. Disconnect a wire from the plug - the storage battery.
2. Remove a ware box from outside the driver.
3. Remove подрулевой the switch (subsection 10.11 see).
4. Disconnect колодку 1 (fig. Connecting Pads the switch (the lock) ignitions see) with wires of the switch (lock) of ignition.
5. Disconnect колодку 4 with immobilizer wires.
6. Disconnect from a steering column "a mass" wire 3.
7. Turn on two plastic nuts 1 (fig. casing Fastening карданного a shaft of a steering column) fastenings of a casing 2 карданного a shaft of a steering column see and remove a casing.
8. Turn away a coupling bolt 4 (fig. Fastening of a shaft of a steering column to a shaft приводной gear wheels of the steering mechanism see) plugs карданного the hinge.
9. Remove upwards a plug 2 карданного the hinge from a shaft 1 приводной gear wheels of the steering mechanism.
10. Having opened a cover of the holder 2 (Fastening of a plait of wires fig. see a steering column on the left side) on the left side, take out from it a plait of 1 wires going to the switch (lock) of ignition.
11. Shift in a direction specified by an arrow, and remove from a steering column the additional holder 3 with a plait 1.
12. Having opened a cover 4 (Fastening of a plait of wires fig. see a steering column on the right side) holder, take out from it a plait of 1 wires.
13. Shift in a direction specified by an arrow, and remove from a steering column the additional holder 3 with a plait 1.
14. Mark from below a relative positioning of the top and bottom parts of a shaft of a steering column (fig. Marks of a relative positioning of the top and bottom parts of a shaft of a steering column see).
15. Fasten to the help of a wire among themselves top 2 (fig. the Steering column in gathering see) and the bottom 1 parts of a steering column.

The prevention

If it is supposed to establish again a removed steering column, do not separate the top and bottom its parts as them шлицы were earned extra to each other and at other position шлицев in connection can appear люфт. Besides, on the shaft greased консистентной with greasing, the dirt can get.


16. Turn away a back bolt 4 (fig. Back fastening of a steering column see) fastenings of a steering column.
17. Turn away two forward bolts 12 (fig. Fastening of a steering column see) fastenings of a steering column.
18. Remove a steering column 11.
19. Replace the holder 1 (fig. Fastening of the holder of plugs see) with the worn out or damaged plugs. For this purpose turn away a bolt of 2 fastenings and take out the holder 1 of a plug 3 on a steering column.
20. At replacement of a steering column remove from it the switch (lock) of ignition as in spare parts a steering column deliver only with the switch case.

Installation

PERFORMANCE ORDER
1. Establish if necessary the holder 1 (Fastening of the holder of plugs) plugs in a plug 3 fig. see a steering column and fix its bolt 2.
2. Establish, at necessity, the switch (lock) of ignition.
3. Establish a steering column 11 (fig. Fastening of a steering column) on an arm see and screw a back bolt of 9 its fastenings by hand, without tightening (a bolt head should be on the right side).
4. Screw forward bolts of 12 fastenings of a steering column, preliminary выровнив apertures under them on an arm 4 and a steering column.
5. Tighten a back bolt of 9 fastenings of a steering column the demanded moment.
6. Remove a transport clamp 3 (fig. the Steering column in gathering see) on a new column or a wire – on old.
7. Further spend assemblage upside-down, having replaced a coupling bolt 13 (fig. Fastening of a steering column see) plugs карданного the hinge with the new.

The inhaling moments, Нм

Bolt of fastening of the holder of plugs in a plug of a steering column
7
Forward bolts of fastening of a steering column
23
Back bolt of fastening of a steering column
20
Coupling bolt of a plug карданного the hinge
20, then to tighten on 90