Skoda Fabia

Since 2000 of release

Repair and car operation

7.2.7. Removal and installation of the stabilizer of cross-section stability

PERFORMANCE ORDER

1. Remove грязезащитный a guard картера the engine. 2. Turn away two bolts 3 (fig. in subsection 7.1.2 see) fastenings of a back support 2 power units to a transmission. 3. Turn on from both parties of a suspension bracket on two bolts 2 (fig. Fastening of a holder of a pillow of the stabilizer see) fastenings of holders of pillows of a bar of the stabilizer. The bottom bolt on the right side can be taken only after the beam of a forward suspension bracket will be lowered. 4. Turn on from both parties of a suspension bracket on one nut 1 (fig. rack Fastening to a bar of the stabilizer of cross-section stability) fastenings see and disconnect racks 3 from a bar 2 stabilizers. 5. Turn away bolts 1 (fig. Fastening of the steering mechanism to a beam of a forward suspension bracket see) fastenings of the steering mechanism to a beam 2 forward suspension brackets. 6. Fix the steering mechanism by means of a wire. 7. Lower a beam approximately on 40 mm (subsection 7.2.5 see). 8. Remove both holders of pillows of a bar of the stabilizer. 9. Having turned the bent ends of a bar of the stabilizer upwards, deduce a bar towards a back part of the car. 10. Replace the pillows of a bar of the stabilizer torn or lost elasticity. 11. Establish a stabilizer bar into place. Carving connections of a suspension bracket definitively tighten on the car standing on the earth.