Skoda Fabia

Since 2000 of release

Repair and car operation



Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
- 7. Transmission and a running gear
   + 7.1. A transmission
   + 7.2. A forward suspension bracket
   - 7.3. A back suspension bracket
      7.3.1. Removal and installation of a nave of a wheel (the drum-type brake mechanism)
      7.3.2. Removal and installation of a nave of a wheel (the disk brake mechanism)
      7.3.3. Removal and pin installation (drum-type brake to mechanisms)
      7.3.4. Removal and pin installation (the disk brake mechanism)
      7.3.5. Removal and shock-absorber installation
      7.3.6. Removal and spring installation
      7.3.7. Removal and installation of a back suspension bracket
      7.3.8. Check and adjustment of corners of installation of wheels
+ 8. A steering
+ 9. Brake system
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes
75d7f213



7.3.2. Removal and installation of a nave of a wheel (the disk brake mechanism)
THE GENERAL DATA

The prevention

At an exit of the bearing of a nave out of operation it is recommended to replace the bearing in gathering with a nave.


PERFORMANCE ORDER
1. Cautiously bring down a protective cap 5 (fig. of the Detail of a back suspension bracket with disk brakes) nuts of a nave see and remove it.
2. Loosen the an inhaling of a nut of 6 naves (a nut двенадцатигранная) and bolts of 2 fastenings of a wheel.
3. Lift and establish on reliable support a back part of the car.
4. Remove a wheel, having turned on definitively bolts of its fastening.
5. Turn away two bolts of 16 fastenings and remove from a flange of a beam of a back suspension bracket directing 1 колодок in gathering with a support. Suspend directing 1 колодок on a wire to a suspension bracket spring, watching that the brake hose did not stretch, it was not overwound and strongly it was not bent.
6. Turn out the screw of 3 fastenings of a brake disk.
7. Remove a brake disk 4 from a nave. At the complicated removal shift a disk a rubber or polymeric hammer.
8. Definitively turn away a nut of 6 naves.
9. Cautiously, without warping, remove a nave 7 from a pin.
10. Напрессуйте a nave 7 on a pin 15, without supposing перекашивания a nave.
11. Screw a new nut of 6 naves. Definitively tighten a nave nut on the car standing on the earth.
12. Establish a brake disk and a wheel.
13. Necessarily replace the broken or deformed cap of 5 naves.

The inhaling moments, Нм

Nut of a nave of a wheel
70, then to tighten on 30
The screw of fastening of a brake disk
4
Bolts of fastening of a wheel
120