Skoda Fabia

Since 2000 of release

Repair and car operation



Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
+ 9. Brake system
+ 10. An electric equipment
- 11. A body
   11.1. Removal and installation of a skeleton of a motor compartment
   + 11.2. A forward door
   - 11.3. A back door
      11.3.1. Removal and installation
      11.3.2. Removal and installation of the external handle of the lock
      11.3.3. Removal and lock installation
      11.3.4. Replacement of sealants
   + 11.4. Seats
   + 11.5. Seat belts
   11.6. Removal and installation of the panel of devices
   11.7. Removal and tjagovo-drawbar installation
   + 11.8. A heater
+ 12. Electroschemes


75d7f213

11.3.2. Removal and installation of the external handle of the lock
THE GENERAL DATA

Prorate removal

1 – a sealant;

2 – the external handle of a door;

3 – the prorate;

4 – face a key

Details of the lock of a back door

1 – the lock;
2 – draught of the external handle;
3 – an arm;
4 – the holder;
5 – the screw of fastening of the holder;
6 – the external handle;
7 – prorate facing;
8 – the prorate;
9 – a prorate lining;
10 – a bolt of fastening of the prorate

PERFORMANCE ORDER
1. Open a door and unstick a sealant 1 (fig. prorate Removal see) doors opposite to the external handle of 2 doors.
2. Delay the external handle of 2 doors and, keeping it in this position, turn on a face key 4 bolt of fastening of the prorate on 2–3 turns. Then take out the prorate 3 on itself.

The prevention

Turn on a bolt exactly on so much that it was possible to take out the prorate. Otherwise the prorate clamp will fall in a door.


3. Press the handle 1 (fig. Removal of the external handle of a door) to the panel of a door see and disconnect a tip of 2 draughts from the handle 1.
4. Take out the handle 6 (fig. of the Detail of the lock of a back door see) of a door, having deduced a hook in a forward part of the handle from gearing with the holder 4.
5. Get a hook on a forward part of the handle in gearing with the holder 4 and insert the handle 6 into place.
6. Press the handle 1 (fig. Removal of the external handle of a door) to the panel of a door see and connect to it a tip of draught 2.
7. Check up lock work. If the handle does not come back in a starting position, means, the end оттяжной springs 4 (fig. spring Connection to the lever of the external handle see) has jumped out of the lever 3. To connect a spring to the lever, insert into an aperture under the prorate a hook 1, hook it on the end of a spring 4 and enter it into a hook of the lever 3.
8. Establish into place the prorate and paste a sealant.