Skoda Fabia

Since 2000 of release

Repair and car operation



Shkoda Fabija
- 1.1. The car description
   + 1.2. Technical characteristics of cars
   1.3. Nameplate data
   1.4. Keys
   1.5. Doors
   1.6. A cowl
   1.7. A luggage carrier
   1.8. Adjustment of seats
   1.9. Increase in capacity of a luggage carrier
   1.10. Seat belts
   + 1.11. Pillows of safety of system Airbag
   1.12. Safety of children
   1.13. Car refuelling
   1.14. Fuel
   1.15. Controls
   1.16. A combination of devices
   1.17. The block of control lamps
   1.18. The gear change lever
   1.19. The lever of a lay brake
   1.20. Adjustment of a steering column
   1.21. The switch (lock) of ignition
   1.22. The podrulevoj switch
   1.23. Illumination of devices
   1.24. The proof-reader of headlights
   1.25. The central switch
   1.26. Cigar Lighter
   1.27. An ashtray
   1.28. Ware boxes
   1.29. The alarm system
   1.30. Heating of forward seats
   1.31. Heating of back glass
   1.32. The switch антипробуксовочной systems (ASR)
   1.33. Ventilation and salon heating
   1.34. The conditioner
   1.35. Rear-view mirrors
   1.36. window raiser with the electric drive
   1.37. Sun-protection peaks
   1.38. The hatch in a roof with the electric drive
   1.39. A sdvizhnaja roof with the electric drive
   1.40. Salon illumination
   1.41. A luggage carrier on a roof
   1.42. The Tjagovo-drawbar
   1.43. Обкатка the car
   1.44. Engine start-up
   1.45. An engine stop
   1.46. Start-up of the engine from an external source
   1.47. Start-up of the engine by towage
   1.48. Car towage
   1.49. A car raising
   + 1.50. Wheels and tyres
   1.51. Cleaners and washers of glasses
   1.52. The storage battery
   1.53. Care of the car
   1.54. The service book
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
+ 9. Brake system
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes



1.33. Ventilation and salon heating
THE GENERAL DATA

The control panel a heater

1 – the handle of adjustment of temperature;
2 – the handle of the switch of the fan;
3 – the management handle заслонками a heater;
4 – the button of the switch of the conditioner;
5 – the switch button recycling air

The handle 1 regulates temperature of air arriving in salon. At handle installation in a dark blue zone in salon not warmed-up air arrives. At handle installation in other positions air is warmed up approximately to the temperature specified on a scale. The red zone specifies that in salon as much as possible warmed-up air arrives.

The handle 2 regulates speed of rotation of the fan of a heater. In position 1 speed of the fan minimum, in position 4 – maximum, positions 2 and 3 – intermediate. In position 0 fan is switched off.

The handle of 3 managements заслонками a heater can be established in following positions:
 – – The maximum stream of air goes on having blown in wind and lateral glasses;
 – – The maximum stream of air passes through the central and lateral nozzles;
 – – The maximum stream of air is directed downwards on having blown in spaces for feet at forward and back seats;
 – – Air stream in regular intervals arrives from all snuffled.

The button 4 joins and switches off the conditioner (if it is established).

By pressing the button 5 switches recycling air заслонка in a heater are blocked by receipt of external air and through a heater air from car salon circulates. Thus in the button illumination lights up. The system recycling is intended for acceleration of warming up of salon.


The prevention

The system recycling is not recommended to be included for long time as car glasses can mist over.


Receipt of a stream of air in salon

 
1 – a nozzle blowing a wind window;
2 – a nozzle blowing lateral glasses;
3 – the central nozzles;
4 – a lateral nozzle;
5 – a nozzle blowing spaces for feet

Salon ventilation

The system recycling should be switched off (the button 5, fig. the Control panel a heater) see.

PERFORMANCE ORDER
1. Turn the handle 1 against the stop to the left (a dark blue zone).
2. The handle 2 establish desirable speed of rotation of the fan.
3. Establish the handle 3 in position.
4. Open central 3 (fig. Receipt of a stream of air in salon see) and lateral 4 nozzles on the panel of devices.

Salon warming up

PERFORMANCE ORDER
1. Turn the handle 1 (fig. the Control panel a heater) against the stop to the right (a red zone see).
2. The handle 2 establish the maximum speed of rotation of the fan (position 4).
3. Establish the handle 3 in position.
4. Open central 3 (fig. Receipt of a stream of air in salon see) and lateral 4 nozzles on the panel of devices.
5. For short time include system recycling, having pressed the button 5 (fig. the Control panel a heater see).

Maintenance of comfortable temperature in salon

PERFORMANCE ORDER
1. The handle 2 (fig. the Control panel a heater see) establish intermediate speed of rotation of the fan (position 2 or 3).
2. The handle 1 establish desirable temperature.
3. Establish the handle 3 in position.

The prevention

If glasses have misted over, establish the handle 3 between positions and and open lateral nozzles 4 (fig. Receipt of a stream of air in salon see) on the panel of devices.



Elimination обмерзания glasses

PERFORMANCE ORDER
1. Turn the handle 1 (fig. the Control panel a heater) against the stop to the right (a red zone see).
2. The handle 2 establish the maximum speed of rotation of the fan (position 4).
3. Establish the handle 3 in position.
4. For additional blowing lateral glasses open lateral nozzles 4 (fig. Receipt of a stream of air in salon see) on the panel of devices.

Elimination запотевания glasses


PERFORMANCE ORDER
1. Turn the handle 1 (fig. the Control panel a heater) against the stop to the left (a dark blue zone see).
2. The handle 2 establish intermediate speed of the fan (position 2 or 3).
3. Establish the handle 3 in position.
4. For additional blowing lateral glasses open lateral nozzles 4 (fig. Receipt of a stream of air in salon see) on the panel of devices.

The prevention

If glasses do not moisten at обдуве cold air, turn the handle 1 (fig. the Control panel a heater) against the stop to the right (a red zone see).