Skoda Fabia

Since 2000 of release

Repair and car operation



Shkoda Fabija
- 1.1. The car description
   + 1.2. Technical characteristics of cars
   1.3. Nameplate data
   1.4. Keys
   1.5. Doors
   1.6. A cowl
   1.7. A luggage carrier
   1.8. Adjustment of seats
   1.9. Increase in capacity of a luggage carrier
   1.10. Seat belts
   + 1.11. Pillows of safety of system Airbag
   1.12. Safety of children
   1.13. Car refuelling
   1.14. Fuel
   1.15. Controls
   1.16. A combination of devices
   1.17. The block of control lamps
   1.18. The gear change lever
   1.19. The lever of a lay brake
   1.20. Adjustment of a steering column
   1.21. The switch (lock) of ignition
   1.22. The podrulevoj switch
   1.23. Illumination of devices
   1.24. The proof-reader of headlights
   1.25. The central switch
   1.26. Cigar Lighter
   1.27. An ashtray
   1.28. Ware boxes
   1.29. The alarm system
   1.30. Heating of forward seats
   1.31. Heating of back glass
   1.32. The switch антипробуксовочной systems (ASR)
   1.33. Ventilation and salon heating
   1.34. The conditioner
   1.35. Rear-view mirrors
   1.36. window raiser with the electric drive
   1.37. Sun-protection peaks
   1.38. The hatch in a roof with the electric drive
   1.39. A sdvizhnaja roof with the electric drive
   1.40. Salon illumination
   1.41. A luggage carrier on a roof
   1.42. The Tjagovo-drawbar
   1.43. Обкатка the car
   1.44. Engine start-up
   1.45. An engine stop
   1.46. Start-up of the engine from an external source
   1.47. Start-up of the engine by towage
   1.48. Car towage
   1.49. A car raising
   + 1.50. Wheels and tyres
   1.51. Cleaners and washers of glasses
   1.52. The storage battery
   1.53. Care of the car
   1.54. The service book
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
+ 9. Brake system
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes



1.48. Car towage
THE GENERAL DATA

Always take with itself in road a towing cable. It is recommended to use a cable from an artificial fibre or a similar elastic material.


The prevention

Крепите a towing cable only for special eyes. Include the light alarm system according to traffic Rules.

If tow your car with the idle engine, insert a key into the switch (lock) of ignition and include ignition for antijoy ride device deenergizing (at all do not switch off ignition, the steering column differently can be blocked).

At the idle engine you should brake with the big effort as the vacuum amplifier does not work. If the engine is serviceable, start up it that the amplifier of brakes operated, the storage battery was not discharged and it was possible to take advantage of a heater during cold time.


Watch signals of the towing car. Try to support constantly a cable in the tense condition, braking the car. If you the car tow other car, provide at трогании from a place a gradual tension of a towing cable (visually by means of a rear-view mirror and on increase in loading at the engine) and only then smoothly increase speed of movement. Do not suppose sharp accelerations, braking and turns. Keep the right number and needlessly do not change a lane. Earlier, than usually, include turn indexes. Do not exceed the speed of towage specified in Rules of traffic.

FORWARD TOWING EYE

The forward towing eye demountable, is stored in a tool box.

Removal and installation

PERFORMANCE ORDER
1. By means of a screw-driver wring out two clamps (places of their arrangement are specified by arrows) the right ventilating lattice 1 (since the clamp nearest to the centre) and remove a lattice from the forward buffer 2.
. 2. Screw an eye 1 in an axis 3. Insert, for example, an assembly shovel in an aperture of an eye and tighten an eye (2 – the forward buffer).
3. After towage of the car to destination remove an eye 1, put it in a tool box and establish a ventilating lattice, reliably having fixed it in the forward buffer.

BACK TOWING EYE

The back towing eye 1 is located under the back buffer 2 on the left side.