Skoda Fabia

Since 2000 of release

Repair and car operation


Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
- 9. Brake system
   + 9.1. Pedal knot
   9.2. The vacuum amplifier
   9.3. The main brake cylinder
   9.4. A pressure regulator (on models without ABS)
   + 9.5. The brake mechanism of a forward wheel of type FS III
   + 9.6. The brake mechanism of a forward wheel of type FS II
   - 9.7. The brake mechanism of a back wheel (drum-type)
      9.7.1. Replacement brake колодок
      9.7.2. Replacement of a brake drum
      9.7.3. Replacement of the wheel brake cylinder
   + 9.8. The brake mechanism of a back wheel (disk)
   + 9.9. A lay brake
   + 9.10. Antiblocking system (ABS)
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes


75d7f213

9.7.2. Replacement of a brake drum
THE GENERAL DATA

Data brake колодок

  

Installation of the brake drum-type mechanism of a back wheel
1 – the screw;
2 – a brake drum;
3 – a protective cap;
4 – a nave nut;
5 – a nave;
6 – a bolt of fastening of a brake board;
7 – a brake board in gathering with the brake mechanism;
 8 – a cable of a drive of a lay brake;
9 – an axis pin;
10 – a brake tube;
11 – the gauge of frequency of rotation of a wheel;
12 – заглушка (on models without ABS);
13 – a bolt of fastening of the gauge;
14 – a beam of a back suspension bracket;
15 – a beam of a back suspension bracket (an execution variant)

The defective brake drum reduces durability brake колодок, leads to inefficient and non-uniform braking.

PERFORMANCE ORDER
1. Replace a brake drum if its internal diameter has reached the maximum admissible value.
2. If on a working surface of a drum there were deep risks, сколы or ovality is appreciable, also it is necessary to replace such drum.
3. Remove a wheel, preliminary having weakened bolts of its fastening on the car standing on the earth.
4. Be convinced that the lever of a lay brake is lowered against the stop downwards (the lay brake is released).
5. Reduce brake Pads. For this purpose through an aperture under bolts of fastening of wheels in a drum by means of a screw-driver (fig. Data brake колодок see) wring out upwards an adjusting wedge (on a wedge for this purpose there is a special ledge).
6. Turn away the screw 1 (fig. Installation of the brake drum-type mechanism of a back wheel see) fastenings of a brake drum to a nave.
7. Remove a brake drum 2. At the complicated removal shift a disk a rubber or polymeric hammer.
8. Establish a new brake drum and fix its screw 1.
9. Bolts of fastening of a wheel definitively tighten only on the car standing on the earth.
10. Some times press a pedal of a brake for automatic adjustment of position brake колодок.

Internal diameter of a brake drum, mm:
  – The nominal
200
  – As much as possible admissible
201

The moment of an inhaling of the screw of fastening of a brake drum – 4 Нм.