|
Removal of a pedal of an accelerator
|
|
1 – an arm of pedals;
2 – connecting колодка;
3 – the gauge of position of a pedal of an accelerator;
4 – a nut of fastening of a pedal;
5 – an accelerator pedal
|
The accelerator pedal is not connected mechanically with throttle заслонкой. On a pedal the gauge of 3 positions of a pedal is established, by pressing a pedal the signal from the gauge arrives in the block of engine management which in turn gives a command on opening throttle заслонки.
In case of need change a pedal 5 in gathering with the gauge 3, as this design not folding.
| PERFORMANCE ORDER |
| 1. Disconnect a wire from the plug - the storage battery. |
| 2. Remove the bottom facing of the panel of devices from outside the driver (subsection 11.6 see). |
| 3. Disconnect колодку 2 with wires from the gauge 3. |
| 4. Turn away three nuts of 4 fastenings and remove a pedal 5 in gathering. |
| 5. Establish a pedal upside-down. The moment of an inhaling of a nut of fastening of a pedal of an accelerator 10 Нм. |
|
|
