Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
- 4. The power supply system
4.1. Removal and installation of the air filter
4.2. Replacement of a filtering element of the air filter
4.3. Replacement of the gauge of the index of level of fuel
4.4. Removal and installation of a fuel tank
4.5. Check of the air valve
4.6. Check of the gravitational valve
4.7. Replacement of the fuel filter
4.8. Check of the valve of heating of fuel
4.9. Replacement of an adsorber of system of catching of steams of fuel
4.10. Replacement of a fuel radiator
4.11. Removal and installation of the vacuum pump of the diesel engine
4.12. Removal and installation of an inlet pipe of the engine
4.13. Removal and installation of a pedal of an accelerator
+ 4.14. Removal and installation of atomizers
4.15. Check of a feed circuit of atomizers of the petrol engine
4.16. Check of resistance of a pump-atomizer
4.17. Check of candles накаливания the diesel engine of 1,9 l, 47 kw
4.18. Check of a feed circuit of candles накаливания
4.19. Check of the gauge of temperature of a cooling liquid
4.20. Check of the gauge of temperature of air arriving in the engine
4.21. Check of the gauge of temperature of fuel of the diesel engine of 1,9 l, 74 kw
4.22. Check of the gauge of frequency of rotation of a cranked shaft
4.23. Check of a drive throttle заслонки
4.24. Check of the gauge of position of a camshaft
4.25. Check элекромагнитного the valve recycling the fulfilled gases
4.26. Check of the relay of the fuel pump of engines of 1,4 l, 55 and 74 kw
4.27. Check of the electromagnetic valve of a purge of an adsorber
4.28. Removal and installation турбокомпрессора
4.29. Removal and installation of an intermediate cooler of air
4.30. Check of the valve of pressure of pressurisation
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
+ 9. Brake system
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes
|
The relay block
At check the storage battery should be charged (the minimum pressure of the battery 11,5).
The relay is established in the block of the relay in the panel of devices behind the block of safety locks. Relay number on cars of release till January, 2000 – 15 (fig. the relay Block see), release since February, 2000 – 4.
| PERFORMANCE ORDER |
| 1. Remove the bottom facing of the panel of devices from outside the driver (subsection 11.6 see). |
| 2. Take out a safety lock 61 of the block of safety locks and connect the indicator of pressure with a light-emitting diode between any contact of a safety lock and "weight". |
| 3. Include a starter, the relay should work (click) is audible, and the light-emitting diode should light up. If the light-emitting diode does not burn, and the relay has worked, connect the indicator to other contact of a safety lock. If the light-emitting diode again does not burn, check up on breakage a wire between contact 8 relays and a safety lock 61. |
| 4. If the relay at inclusion of a starter has not worked, connect the voltmeter to contacts 2 and 6 relays, then 9 and 6. In both cases the voltmeter should show pressure of the storage battery. Otherwise check up wires on breakage and short circuit. |
| 5. If pressure is equal to pressure of the storage battery, connect the pressure indicator to contacts 1 and 2 (or 9), and then to contacts 7 and 6. Include a starter if the light-emitting diode burns in both cases, replace the relay block if does not burn, eliminate breakage in conducting. |
|
|
|
