| 1. Disconnect a wire from the plug - the storage battery. On a part of cars the holder of the storage battery (большего the size) closes a receiver cover. In this case it is necessary to remove the storage battery and its holder (subsection 10.2 see). |
| 2. Establish a steering wheel in the position corresponding rectilinear movement of the car. It is recommended to fix a steering wheel, for example, a sticky tape 2 (fig. in subsection 8.4.2 item 1 see). |
The prevention During repair it is forbidden to turn a steering wheel as the mechanism of a pillow of safety can fail.
|
| 3. Turn on two plastic nuts 1 (fig. casing Fastening карданного a shaft of a steering column) casing fastenings карданного a shaft of a steering column see and remove a casing 2. |
| 4. Turn away a coupling bolt 4 (fig. Fastening of a shaft of a steering column to a shaft приводной gear wheels of the steering mechanism see) plugs карданного the hinge. |
| 5. Remove upwards a plug 2 карданного the hinge from a shaft 1 приводной gear wheels of the steering mechanism. |
| 6. If necessary remove the air filter (subsection 4.1 see). |
| 7. 7. Take out a wire 2 (fig. Elements of the hydraulic amplifier of a steering see) gauge of the amplifier of a steering from three holders 4. |
| 8. Remove грязезащитный a guard and forward wheels. |
| 9. On models with the reception pipe of the muffler which are passing under a beam of a forward suspension bracket, remove a reception pipe with neutralizer. |
| 10. Disconnect a back support 20 (Fastening of the steering mechanism fig. see the car (with the amplifier)) from a transmission, having turned away two bolts of 19 fastenings. |
| 11. Turn on on one nut 1 (fig. rack Fastening to a bar of the stabilizer of cross-section stability) fastenings see and disconnect racks 3 from a bar 2 stabilizers from both parties of a suspension bracket. |
| 12. Disconnect tips of both steering draughts from rotary levers (subsection 8.5.1 see). |
| 13. Turn away a cover 9 (fig. Elements of the hydraulic amplifier of a steering) a receiver see and through a bulk mouth remove by means of a rubber pear a working liquid from a receiver. |
| 14. Establish under the steering mechanism capacity for gathering of a liquid which will follow from it at removal. |
| 15. Establish a reliable support under a beam of a forward suspension bracket. |
| 16. Turn away bolts 18 (Fastening of the steering mechanism fig. see the car (with the amplifier)) fastenings of the steering mechanism to a beam 21 forward suspension brackets. |
| 17. Lower a beam of a forward suspension bracket (subsection 7.2.5 see) approximately on 40 mm, without supposing damage of a wire of the gauge and highways of the amplifier of a steering. |
| 18. Turn away a hollow bolt of 14 fastenings and disconnect from картера the steering mechanism at first a pressure head highway 16, then a returnable highway 12, having turned away a nut of its fastening. Muffle apertures of highways and in картере the steering mechanism. |
| 19. Turn away two bolts of 7 fastenings with internal шестигранниками and disconnect the gauge 6 amplifiers of management from the steering mechanism. |
| 20. Cautiously lower a beam 21 forward suspension brackets. |
| 21. Remove the steering mechanism, having deduced it towards a back part of the car. |
