Skoda Fabia

Since 2000 of release

Repair and car operation


Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
- 8. A steering
   8.1. Removal and steering wheel installation
   8.2. Removal and installation of returnable and contact rings in gathering
   + 8.3. A steering column
   + 8.4. The steering mechanism (without the amplifier)
   - 8.5. The steering mechanism (with the amplifier)
      8.5.1. Replacement of a tip of steering draught
      8.5.2. Removal of the steering mechanism
      8.5.3. Installation of the steering mechanism
      8.5.4. Replacement of steering draught
      8.5.5. The pump unit
      8.5.6. Check of electric chains of the amplifier of a steering
      8.5.7. Replacement of the gauge of the amplifier of a steering
      8.5.8. Replacement of highways of system of the amplifier of a steering
      8.5.9. Check of level of a working liquid
      8.5.10. Refuelling and removal of air from hydraulic system
      8.5.11. Check and adjustment of corners of installation of wheels
+ 9. Brake system
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes


75d7f213

8.5.6. Check of electric chains of the amplifier of a steering
THE GENERAL DATA

Designations of contacts connecting колодок

 And – CAN-BUS Low;
– CAN-BUS High;
In – reserve;
г – 15;
д – 30;
е – "weight";
1 – connecting колодка tyres CAN-BUS;
2 – connecting колодка a food
PERFORMANCE ORDER
1. Check up serviceability of safety locks and pressure of the storage battery which than 11,5 Century should be not less
2. Remove локарь niches of a forward left wheel.
3. Disconnect a wire from the plug - the storage battery.
4. Disconnect колодку 2 tyres CAN-BUS with wires (fig. Connecting Pads the pump unit see) and колодку a food 3.
5. Again connect a wire to the plug - the storage battery and include ignition.
6. Connect the voltmeter to contacts г (fig. of the Designation of contacts connecting колодок see) Pads 1 tyres CAN-BUS and "weight" of the car. Pressure should be approximately equal to pressure of the storage battery.
7. Connect the voltmeter to contacts д and е Pads 2 foods, and then to contacts д and "weight" of the car. Pressure should be approximately equal in these two cases to pressure of the storage battery.
8. Switch off ignition.
9. Connect an ohmmeter to contacts г Pads 1 tyres CAN-BUS and "weight" of the car. The device should show infinity.
10. Connect an ohmmeter to contacts д Pads 2 foods and "weight" of the car. The device should show infinity.
11. Connect an ohmmeter to contacts е Pads 2 foods and "weight" of the car. Resistance should be nearby 0.
12. Connect an ohmmeter to contacts д and е Pads 2 foods. Resistance should be nearby 60 Ohm.
13. If results any of checks do not correspond to the specified values, check up Pads and wires of corresponding chains.
The prevention

Connect Pads with wires only at the disconnected plug - the storage battery.