| 1. Check up and, if necessary, adjust position рейки the steering mechanism (subsection 8.4.4 see). |
| 2. Grease with a soap solution a pillow 9 (fig. of the Detail of the steering mechanism (with the amplifier see)) support of the steering mechanism to facilitate installation on it fixing скобы 10. |
| 3. Establish the steering mechanism 22 (Fastening of the steering mechanism fig. see the car (with the amplifier)) on a beam 21 forward suspension brackets and screw new bolts of 18 its fastenings, definitively without tightening them. |
| 4. Check up correctness of installation of a sealant 11 (fig. of the Detail of the steering mechanism (with the amplifier see)) on the case of the steering mechanism. |
| 5. Cautiously lift a beam so that it was possible to connect highways and the gauge to the steering mechanism, having entered thus into a board aperture передка a shaft приводной gear wheels of the steering mechanism. |
| 6. Connect the gauge 6 (Fastening of the steering mechanism fig. see the car (with the amplifier)) the amplifier to the steering mechanism, having established a new lining 5, and fix two bolts 7 with internal шестигранниками. |
| 7. Connect to картеру the steering mechanism pressure head 16 and returnable 12 highways, using thus new sealing rings 13 and 15. Pay attention, at a returnable highway a sealing ring of round section. |
| 8. Fix a beam of a forward suspension bracket. |
| 9. Tighten the corresponding moment new bolts of 18 fastenings of the steering mechanism to a beam of a forward suspension bracket. |
| 10. Connect steering bent for to rotary levers. |
| 11. Connect racks to a bar of the stabilizer of cross-section stability and screw up fastening nuts. |
| 12. Attach a back support 20 to a transmission two new bolts 19. |
| 13. On models with the reception pipe of the muffler which are passing under a beam of a forward suspension bracket, establish a reception pipe with neutralizer. |
| 14. Establish грязезащитный a guard and forward wheels. |
| 15. Lower the car on wheels. |
| 16. Fix a wire of the gauge of the amplifier of a steering in three holders 4 (fig. Elements of the hydraulic amplifier of a steering see). |
| 17. Put on a shaft приводной gear wheels of the steering mechanism a plug 3 (Fastening of the steering mechanism fig. see the car (with the amplifier)) карданного the hinge and fix a plug a new coupling bolt 4. |
| 18. Insert into a board aperture передка a sealant 11 (fig. of the Detail of the steering mechanism (with the amplifier see)). Be convinced that it has settled down exactly and densely. |
| 19. Establish a casing 2 (fig. casing Fastening карданного a shaft of a steering column) карданного a shaft of a steering column see and fix its two plastic nuts 1. |
| 20. Fill in a working liquid in hydraulic system of the amplifier of a steering (subsection 8.5.10 see). |
| 21. Establish into place the storage battery. |
| 22. Establish the air filter if it removed. |
| 23, Check up and, if necessary, adjust corners of installation of wheels. |
| 24. It is recommended to check up at servicing deport work of an electric part of system of the amplifier of a steering by means of the special electronic device. |
