Skoda Fabia

Since 2000 of release

Repair and car operation

Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
- 9. Brake system
   + 9.1. Pedal knot
   9.2. The vacuum amplifier
   9.3. The main brake cylinder
   9.4. A pressure regulator (on models without ABS)
   + 9.5. The brake mechanism of a forward wheel of type FS III
   + 9.6. The brake mechanism of a forward wheel of type FS II
   + 9.7. The brake mechanism of a back wheel (drum-type)
   + 9.8. The brake mechanism of a back wheel (disk)
   - 9.9. A lay brake
      9.9.1. Adjustment of a lay brake with back drum-type brakes
      9.9.2. Adjustment of a lay brake with back disk brakes
      9.9.3. Lever replacement
      9.9.4. Replacement of cables
      9.9.5. Replacement of a brake liquid
      9.9.6. Prorolling of brake system
   + 9.10. Antiblocking system (ABS)
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes

9.9.3. Lever replacement

THE GENERAL DATA

Installation of the lever of a lay brake

1 – the lever;
2 – a lever casing;
3 – the equalizer;
4 – an adjusting nut;
5 – the sealing plug;
6 – a directing tube;
7 – a cable of a drive lay
Brakes;
8 – a lever support;
9 – the switch of a control lamp of a lay brake;
10 – a nut of fastening of the lever

PERFORMANCE ORDER

1. Disconnect a wire from the plug - the storage battery.

2. Remove the floor console.

3. Lower the lever of a lay brake against the stop downwards.

4. Disconnect a wire from the switch 9 (fig. Installation of the lever of a lay brake see) control lamp of a lay brake.

5. Loosen the an adjusting nut 4 also disconnect tips of cables 7 from the equalizer 3.

6. Turn on two nuts of 10 fastenings of the lever.

7. Remove the lever 1 from a support 8.

8. If necessary remove from the lever the switch 9 control lamps of a lay brake and the equalizer 3.

9. To remove a casing 2, wring out a screw-driver a latch from the bottom party of a casing and remove a casing, shifting it on the lever. Establishing a casing into place, pull it over the lever against the stop that it was fixed by a latch.

10. Establish the lever of a lay brake upside-down. Thus replace nuts of fastening of the lever new. Adjust a lay brake.

The inhaling moment гайек lever fastenings – 20 Нм to tighten on 90 .