Skoda Fabia

Since 2000 of release

Repair and car operation



Shkoda Fabija
+ 1.1. The car description
+ 2. The engine
+ 3. Greasing system
+ 4. The power supply system
+ 5. Cooling system
+ 6. System of release of the fulfilled gases
+ 7. Transmission and a running gear
+ 8. A steering
- 9. Brake system
   + 9.1. Pedal knot
   9.2. The vacuum amplifier
   9.3. The main brake cylinder
   9.4. A pressure regulator (on models without ABS)
   + 9.5. The brake mechanism of a forward wheel of type FS III
   + 9.6. The brake mechanism of a forward wheel of type FS II
   + 9.7. The brake mechanism of a back wheel (drum-type)
   + 9.8. The brake mechanism of a back wheel (disk)
   - 9.9. A lay brake
      9.9.1. Adjustment of a lay brake with back drum-type brakes
      9.9.2. Adjustment of a lay brake with back disk brakes
      9.9.3. Lever replacement
      9.9.4. Replacement of cables
      9.9.5. Replacement of a brake liquid
      9.9.6. Prorolling of brake system
   + 9.10. Antiblocking system (ABS)
+ 10. An electric equipment
+ 11. A body
+ 12. Electroschemes
75d7f213



9.9.4. Replacement of cables
PERFORMANCE ORDER
1. Remove the floor console.
2. Raise and establish on reliable support a back part of the car.
3. Remove a wheel, preliminary having weakened bolts of its fastening on the car standing on the earth.
4. Lower the lever of a lay brake against the stop downwards.
5. Loosen the an adjusting nut 4 (fig. Installation of the lever of a lay brake see) and disconnect tips of cables 7 from the equalizer 3.
6. Disconnect the holder 9 (fig. of the Detail of a back suspension bracket with drum-type brakes see) from a beam of a back suspension bracket.
7. Disconnect cables from spring holders 16.
The drum-type brake mechanism
8. Remove a brake drum.
9. Disconnect a cable from the lever 8 (fig. of the Detail of the brake drum-type mechanism of a back wheel see) manual drive.
10. Pull out a tip of a cable from a brake board 14.
11. Take out a cable 7 (fig. Installation of the lever of a lay brake see) of a directing tube 6.
The disk brake mechanism
12. Having hooked a screw-driver, remove spring скобу 1 (fig. the Detachment of a cable of a drive of a lay brake see).
13. Having wrung out the lever 6 manual drives in a direction specified by an arrow, disconnect from it a cable 4 drives of a lay brake.
14. Take out a cable 7 (fig. Installation of the lever of a lay brake see) of a directing tube 6.
15. Establish a cable upside-down.
16. Thus replace the holder 9 (fig. of the Detail of a back suspension bracket with drum-type brakes see) cable. The ring on a cable cover should be between collars of the holder 9.
17. Adjust a lay brake.