Skoda Fabia

Since 2000 of release

Repair and car operation

4.14.2. Petrol engines of 1,4 l, 55 and 74 kw

THE GENERAL DATA

Details of system of injection of fuel of petrol engines of 1,4 l, 55 and 74 kw

1 – a stopper маслоналивной mouths; 2 – the top casing of the engine with the air filter; 3 – the holder of wires; 4 – a bolt of fastening of a fuel stage; 5 – the union for pressure measurement in system; 6 – a fuel stage with atomizers; 7 – a bolt of fastening of an inlet pipe of the engine; 8 – a vacuum hose of the amplifier of brakes; 9 – connecting колодка a drive throttle заслонки; 10 – a hose of a purge of an adsorber; 11 – an inlet pipe; 12 – a lining; 13 – a bolt of fastening of a tube recycling the fulfilled gases; 14 – a tube recycling the fulfilled gases; 15 – the second ljamda-probe (for the engines answering to norms of Euro-4);

16 – connecting колодка the second ljambda-probe; 17 – a ljambda-probe; 18 – connecting колодка a ljambda-probe; 19 – the gauge of frequency of rotation of a cranked shaft; 20 – a bolt of fastening of the gauge; 21 – a lining of an inlet pipe; 22 – the spring holder; 23 – connecting колодка; 24 – the gauge of temperature of a cooling liquid; 25 – заглушка; 26 – sealing rings; 27 – a bolt of fastening of the case of the thermostat; 28 – the thermostat case; 29 – топливопровод; 30 – connecting Pads the management block; 31 – the engine management block; 32 – a block arm; 33 – bolts of fastening of an arm

Fuel stage with atomizers of engines of 1,4 l, 55 and 74 kw

1 – топливопровод; 2 – the screw of fastening of a fuel stage; 3 – a fuel stage; 4 – the union for pressure measurement in system; 5 – an atomizer clamp; 6 – a sealing ring; 7 – an atomizer

PERFORMANCE ORDER

1. Disconnect a wire from the plug - the storage battery. 2. Remove the top casing of the engine (subsection 2.1 see). 3. Disconnect from atomizers Pads with wires. 4. Disconnect from a fuel stage 3 (fig. the Fuel stage with atomizers of engines of 1,4 l, 55 and 74 kw see) топливопровод 1. 5. Turn away two screws of 2 fastenings of a fuel stage. 6. Having pulled a fuel stage along axes of atomizers, remove it. Thus atomizers should leave apertures in an inlet pipe of the engine and remain on a stage. If any atomizer remained in an inlet pipe, it is necessary to replace its sealing rings 6 and a clamp 5. 7. Remove clamps of 5 atomizers. 8. Having pulled, take out atomizers 7 of a fuel stage 3. 9. Replace clamps of 5 atomizers if will find out on them cracks. 10. Replace the sealing rings of 6 atomizers torn, cracked or lost elasticity. 11. Establish atomizers upside-down. Thus grease with gasoline sealing rings of atomizers.