| 1. Turn a cranked shaft so that both valves of the fourth cylinder have been opened. |
|
2. Loosen the an inhaling of counternuts at коромысел the first cylinder (1 – a counternut; 2 – the adjusting screw; 3 – коромысло the valve; 4 – the valve; 5 – a plastic wedge). |
| 3. Turn out adjusting screws 2 so that between коромыслами 3 and valves 4 there was an appreciable backlash. |
| 4. Screw adjusting screws before contact коромысел with valves, and then on two turns. |
| 5. Keeping adjusting screws in this position, tighten counternuts. |
| 6. Adjust a starting position of other hydropushers, turning a cranked shaft according to the table. |
